Acura 2002 RSX Service Manual page 126

7 . Remove the sealing bolt (A) from the relief hole,
and install the VrEC air stopper (B).
E
OTAAJ-PNAAlOO
D
OTZAJ.PNAA3OO
9 .
1 0 .
OTZAJ.PNAA2OO
07ZAJ.PNAA1O1
Remove the No. 3 camshaft holder bolts, and install
the VTEC air adapters (C) finger-tight.
Connect the air joint adapter (D), and air pressure
regulator with a 0-100 psi gauge (E).
Loosen the valve on the regulator, and apply the
specified air pressure.
Specified air pressure:
290 kPa (3.0 kgf/cm', 42 Psi)
NOTE: lf the synchronizing piston does not move
after applying air pressure; move the rocker arm up
and down manually by rotating the crankshaft.
11. With the specified air pressure applied, move the
s e c o n d a r y r o c k e r a r m ( A ) f o r t h e N o 1 c y l i n d e r .
The mid rocker arm {B), primary rocker arm (C).
and secondary rocker arm should move together.
. lf the mid and primary rocker arms do not move
together with the secondary rocker arm, remove
the mid, primary, and secondary rocker arms as
an assembly, and check that the pistons in the
rocker arms move smoothly. lf any rocker arm
needs replacing. replace the mid, primary and
secondary rocker arms as an assembly, and
TEIESI,
Remove the special tools.
Tighten the camshaft holder mounting bolts to
22 N.m \2.2 kgf.m, 16 lbf.ft).
Tighten the sealing bolt to 20 N m (2 0 kgf m,
1 4 l b f . f t ) .
Install the cyllnder head cover (see page 6-46).
12.
1 4 .
1 5 .
6-9