Setting Output Data - Omron FQ2-S Series User Manual

Performing Continuous Measurements
Continuous measurements are performed while the continuous measurement command is input from an
external device.
Or other
device
PLC

Setting Output Data

You can set the data to output after measurements.
Output Data
You can output any of the following data through the Parallel Interface Sensor Data Unit.
Data Output contents
Overall judgement Judgement result of multiple inspection items
result (ON if even one judgement result is NG)
Parallel judgement Judgement results of the judgement conditions
output that are set for parallel output
Parallel data output Measurement values for inspection items and
results from expressions
Outputting the Overall Judgement Result (OR Signal)
When the results of the inspection items are judged, if even one individual judgement result is NG, the OR
output signal is turned ON.
Note
• You can also turn ON the overall judgement result output signal when all individual judgement results are OK.
Changing the Judgement Output ON Conditions: p. 44
• You can select whether to use the judgement result of one of the calculations (0 through 31) as the overall judge-
ment.
Section 4 Setting Up Inspections
in Vision Sensor FQ2-S/CH Series User's Manual (Cat. No. Z337)
• You can adjust the timing for outputting the OR signal and the ON time after judgement processing.
Adjusting the Judgement Output Timing: p. 42
FQ2-S/CH User's Manual
for Communications Settings
(1) IN7 signal ON (IN0 to IN6 are OFF)
Controlling Operation and Outputting Data with a Parallel Interface Sensor Data Unit
(2) Performs continuous
measurements
Signal used to output the data
The results is output with the OR signal.
The results are assigned to and output with
D0 to D15.
The data is output as 16-bit data on D0 to
D15.
61