Omron FQ2-S Series User Manual page 252

Save Scene Data
This command saves scene data to the SD card inserted in the Touch Finder as a file.
The destination for scene data is the following fixed directory on the SD card.
\Sensor name\SCN
The file name is not case sensitive. The file name extension can be omitted.
Command (PLC to Vision Sensor)
First word of com-
mand area
+2
+3
+4
+5
+6
+7
+8
:
+37
*1 Saved as a file named Scene_***.scn. (***: Specified file number)
Response (Vision Sensor to PLC)
First word of
response area
+2
+3
+4
+5
250
Command Control
Bits
12 to 15 8 to 11 4 to 7
0001 0000 0000
0000 0000 0111
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
Bits
12 to 15 8 to 11 4 to 7
0001 0000 0000
0000 0000 0111
0000 0000 0000
0000 0000 0000
Contents
0 to 3
0000 Command code
0000
0000 Number of the scene to be saved.
0000
0000 • EtherNet/IP,
PROFINET
0000
File number to load
(0 to 999)*1
---
0000
0000
0000
Contents
0 to 3
0000 Command code
Response target command codes
0000
0000 Response code
Command execution result
0000
0: OK, FFFFFFFF: NG
• PLC link
File name to load
64 characters max.
The file name exten-
sion (.scn) can be
omitted.
FQ2-S/CH User's Manual
for Communications Settings