Omron FQ2-S Series User Manual page 428

● Save Calibration Data: 280F 0070A000
This command saves the calibration data with the specified calibration number as a file to the SD card inserted
in the Touch Finder.
The destination for calibration data is the following fixed directory on the SD card.
\Sensor name\CLB
Format
MRC SRC
(1 byte) (1 byte)
28 0F
Response Format
MRC SRC
(1 byte) (1 byte)
28 0F
End Codes
End code (hex)
0000
FFFF
Parameter Descriptions
Calibration number
Calibration data file
name
Important
• If the specified file name already exists, this existing file will be overwritten.
• Do not turn off power to the Vision Sensor until there is a response.
426
Command Control
Vision Sensor command code
(4 bytes)
0070A000
MRES SRES
(1 byte) (1 byte)
End code
Description
Command execution ended normally.
Command execution ended in an error.
Specifies the scene number (0 to 31) to be saved.
Specifies the file name when saving.
The file name extension (.clb) can be omitted.
Calibration Calibration data
number to save file name
(4 bytes) (4 to 64 bytes)
2 digits max. 64 characters
max.
Vision Sensor command code
(4 bytes)
0070A000
FQ2-S/CH User's Manual
for Communications Settings