Omron FQ2-S Series User Manual page 314

SETITEMFIGPARAM or SIFP
Set Inspection Item Measurement Region/Model Region
This command changes the range set as the measurement region or the model registration region for an
inspection item.
This command cannot set a new measurement region or model registration region.
When using this command, execute it for an inspection item that has already been set with a measurement
region or a model registration region.
<Command Format>
S E T I T
or
Inspection
item number
(2 digits max.)
S I F P
Command Space
(0x20)
<Response Format>
When the Command Is Processed Normally
O K CR
Delimiter
When the Command Is Not Processed Normally
E R CR
Delimiter
<Parameter Descriptions>
Inspection item number
Region number
Figure number
Parameter 1 to parame-
ter 21
312
Command Control
Command
E M F I G P A
Region Figure
number number Space
(1 digit) (1 digit) (0x20)
Space Parameter 1
(0x20)
Space
Parameter 2 Parameter 21
(0x20)
Specifies the inspection item number. (0 to 31)
Selects either a measurement region or a model registration region. The value that spec-
ifies each region differs according to the inspection item type.
The measurement region or model registration region range registers a complicated
model or a measurement region by combining a maximum of 8 figures (rectangles, cir-
cles, and other shapes).
Of those figures, specify the figure to change the range of using this command with the
*1
figure number.
Use the Acquire Inspection Item Figure command to check the figure numbers assigned
to each figure in advance.
Acquire Measurement Region/Model Region Information Set for an Inspec-
tion Item: p. 283
The values to be set as the measurement region or the model registration region are split
up and specified in parameter 1 through parameter 21.
Inspection item number
(2 digits max.)
R A M
Space Region
(0x20) number
(1 digit)
Space
(0x20)
Space
(0x20)
CR
...
Delimiter
Figure number Space Space
(1 digit) (0x20) (0x20)
...
Parameter 1 Parameter 21
Parameter 2
Space
(0x20)
*1
*2
FQ2-S/CH User's Manual
for Communications Settings
Delimiter
CR