Omron FQ2-S Series User Manual page 238

Response (Vision Sensor to PLC)
First word of
response area
+2
+3
+4
+5
Set Communication Input Status
This command sets the input status (allowed/prohibited) of the communications port for the specified
communications protocol.
Communications protocols with the input status set to prohibited will no longer receive communications after
being set as such.
However, for inputs related to hardware (parallel STEP signal and DSA signal), this setting is not applicable.
Command (PLC to Vision Sensor)
First word of com-
mand area
+2
+3
+4
+5
+6
+7
Response (Vision Sensor to PLC)
First word of
response area
+2
+3
+4
+5
236
Command Control
Bits
12 to 15 8 to 11 4 to 7
0100 0000 0110
0000 0000 0101
0000 0000 0000
0000 0000 0000
Bits
12 to 15 8 to 11 4 to 7
0111 0000 0001
0000 0000 0011
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
Bits
12 to 15 8 to 11 4 to 7
0111 0000 0001
0000 0000 0011
0000 0000 0000
0000 0000 0000
Description
0 to 3
0000 Command code
The command code for which the response
0000
applies is stored.
0000 Response code
Command execution result
0000
0: OK, FFFFFFFF: NG
Description
0 to 3
0000 Command code
0000
0000 Communications protocol type to be set*
0: No protocol (TCP, UDP, FINS)
0000
1: No protocol (RS-232C)
2: Parallel I/O
3: Fieldbus
5: PLC link
0000 Communications protocol status to be set
0: Input prohibited status
0000
1: Input allowed status
Description
0 to 3
0000 Command code
The command code for which the response
0000
applies is stored.
0000 Response code
Command execution result
0000
0: OK, FFFFFFFF: NG
FQ2-S/CH User's Manual
for Communications Settings