Omron FQ2-S Series User Manual page 211

Response (Vision Sensor to PLC)
First word of
response area
12 to 15
+2 0010
+3 0000
+4 0000
+5 0000
Clear Data Output Buffer
This command clears all data from the data output buffer of the Sensor. If an error occurs in the PLC after
measurement, data will remain in the data output buffer of the Sensor. This command clears the data. The
command prevents deviation of the data after an error occurs. This command only clears the data output buffer
of the Sensor; it does not clear the output area of the PLC.
Command (PLC to Vision Sensor)
First word of com-
mand area
12 to 15
+2 0010
+3 0000
Response (Vision Sensor to PLC)
First word of
response area
12 to 15
+2 0010
+3 0000
+4 0000
+5 0000
Clear Statistical Data
This command clears the statistical data (such as the number of measurements, the number of NG overall
judgments, the NG rate, and other information since the power supply was turned ON) produced by the logging
function held by the Sensor.
Command (PLC to Vision Sensor)
First word of com-
mand area
12 to 15
+2 0010
+3 0000
FQ2-S/CH User's Manual
for Communications Settings
Bits
8 to 11 4 to 7 0 to 3
0000 0001 0000
0000 0001 0000
0000 0000 0000
0000 0000 0000
Bits
8 to 11 4 to 7 0 to 3
0000 0010 0000
0000 0001 0000
Bits
8 to 11 4 to 7 0 to 3
0000 0010 0000
0000 0001 0000
0000 0000 0000
0000 0000 0000
Bits
8 to 11 4 to 7 0 to 3
0000 0110 0000
0000 0001 0000
Contents
Command code
The command code for which the response
applies is stored.
Response code
Command execution result
0: OK, FFFFFFFF: NG
Contents
Command code
Contents
Command code
The command code for which the response
applies is stored.
Response code
Command execution result
0: OK, FFFFFFFF: NG
Description
Command code
209
Command Control