Omron FQ2-S Series User Manual page 225

System Type Item
data num-
ber
103 Logging Measurement
control data
104 Logging Statistical data
control
106 Parallel OR output
control
107 Parallel Output delay
control
108 Parallel Judgment out-
control put mode
109 Parallel One-shot out-
control put time
110 Parallel OUT0 polarity
control
111 Parallel OUT1 polarity
control
112 Parallel OUT2 polarity
control
113 Parallel OUT0 signal
control assignment
FQ2-S/CH User's Manual
for Communications Settings
Data Range
size
4 0: None
1: All
2: NG only
4 0: None
1: Yes
4 0: OK: ON
1: NG: ON
4 0 to 1,000
4 0: Level output
1: One-shot output
4 1 to 1,000
4 0: Positive
1: Negative
4 0: Positive
1: Negative
4 0: Positive
1: Negative
4 0: Control signal
1 to 32: OR0 to 31
1001 to 1032: Expression 1 to 32
2001: OR (overall judgement)
2002: BUSY
2003: ERROR
2004: READY
2005: RUN
2006: STG
Description
Specifies the logging con-
dition for measurement
data for each inspection
item.
Specifies whether or not to
record statistical data
(such as the number of
measurements, number of
NG judgments).
Specifies the polarity when
the OUT0 output signal is
ON.
Specifies the ON delay
time (ms) from when the
measurement processing
completes until output
when using one-shot out-
put.
Specifies whether output is
one-shot output or level
output.
Specifies the ON output
time (ms) when using one-
shot output.
Specifies the polarity for
the OUT0 output signal
(default assignment:
BUSY).
Specifies the polarity for
the OUT1 output signal
(default assignment: OR).
Specifies the polarity for
the OUT2 output signal
(default assignment:
ERROR).
Specifies whether to use
the signal as a control sig-
nal or to use the signal as a
judgment output (OR indi-
vidual output signal) for
inspection items.
Command Control
223