Communication Settings Procedure - Omron FQ2-S Series User Manual

Parameter Description
Data output period This parameter is displayed and can be set only
when [Output handshake] is set to [No]. Set the
period for outputting measurement results.
Important
Set a value that is longer that the GATE ON
output time and shorter than the measurement
interval of the Sensor.
GATE signal ON This parameter is displayed and can be set only
period when [Output handshake] is set to [No].
Set the time to turn ON the GATE signal.
Set the time that is required for the external
device to read the measurement results.
Important
Set a value which is equal or longer than the
[refreshing task period] (or the requested
packet interval).

Communication Settings Procedure

To use PROFINET communication, the settings below must be configured.
Configure network settings of Sensor
Configure default PROFINET settings
• Fieldbus settings
Configure IO supervisor (computer) settings
• IP address settings
Configure IO controller settings
• IP address settings
• PROFINET IO system settings
• IO device settings and assignments
• Compile and save settings
Transfer settings and check connection
• Check IO controller connection
• Transfer parameters
• Check connection status
• Check data assignments
FQ2-S/CH User's Manual
for Communications Settings
Setting range
2 to 5,000 ms (default: 40 ms)
1 to 1,000 ms (default: 20 ms)
Set on the FQ2.
Setting Up EtherNet/IP Communications (PROFINET):
p.145
Configure the settings with the engineering tool.
If you are setting the FQ2 as an IO device, install a GSD file
that defines the FQ2 IO data CR connection information in the
engineering tool.
The FQ2 GSD file can be downloaded from our website.
For PROFINET IO system settings, refer to the engineering tool
manuals.
Actually connect the computer (Engineering Tool), sensor and
external devices, and use the Engineering Tool to transfer the
settings and check communication.
Outputting Data and Controlling Operation through PROFINET
147