Omron FQ2-S Series User Manual page 37

24 V
Power supply
0 V
ON
BUSY
OFF
Note
You can mount a Parallel Interface Sensor Data Unit to enable using other signals and increase the number of sig-
nals that you can use with parallel communications.
And in addition to outputting OR judgement results, you can also use a Parallel Interface Sensor Data Unit to output
the judgement results of judgement conditions that you set for parallel output (called parallel judgement output) and
the results of measurement values and expressions for inspection items (called parallel data output).
Controlling Operation and Outputting Data with a Parallel Interface Sensor Data Unit: p. 60
Configuring the Operation
The following settings can be selected depending on the system configuration and application.
Type of change
Changing the type of measurement trigger
Changing the output method of the judgement
results
Changing the polarity of the BUSY output
Changing the BUSY output condition
Changing the polarity of the output signals
(OUT1 to OUT2)
Selecting the types of commands that can be
used
FQ2-S/CH User's Manual
for Communications Settings
Max 5 sec
Sensor system is initializing.
The time of initializing
depends on the scene data.
Change
Performing continuous measurements
Obtaining individual judgement results
Adjust the judgement output timing
Changing the judgement output ON conditions
Reversing the polarity of the BUSY signal
Adjusting the end timing of the BUSY signal
Reversing the output polarity of OUT1 to OUT2 p. 45
Changing the commands used in IN0 to IN5
Controlling Operation and Outputting Data with the Sensor's Standard Parallel Connection
Turns OFF when the
Sensor is ready for
operation.
Reference
p. 37
p. 41
p. 42
p. 44
p. 44
p. 45
p. 45
35