Basic Procedure - Gestetner CP6143L Operating Instructions Manual

C2678608_Platinum-EN.book Page 30 Sunday, February 12, 2006 10:53 PM
Basics

Basic Procedure

When Auto Cycle mode is on, you
can process masters and make prints
in a single operation.
Note
2
❒ You can process masters and make
prints in a single operation. See
p.35 "Auto Cycle".
❒ If the machine has user codes set,
enter your user code using the
number keys, and then press the
{OK} key.
Reference
See p.109 "User Code".
A
Make sure no previous settings
remain.
Note
❒ If previous settings remain, press
the {Clear Modes/Energy Saver} key
before entering your settings.
B
Place the originals.
Reference
See p.28 "Placing Originals".
C
Make sure the {Master Making} mode
select key is lit.
Note
❒ If it is not lit, press the {Master
Making} mode select key.
D
Make the necessary settings.
30
E
Press the {Start} key.
Master making starts.
Note
❒ Press the {Proof} key to check the
image before making prints.
Reference
To change the image position,
see p.37 "Adjusting the Print
Image Position".
F
Make sure the {Print} mode select
key is lit.
ANT128S
ANT123S
ANT127S