Arp Detection Configuration Commands; Arp Detection Enable - HP E4510-48G Command Reference Manual

undo arp rate-limit
View
Layer 2 Ethernet port view
Default Level
2: System level
Parameters
disable: Disables ARP packet rate limit.
rate pps: ARP packet rate in pps, in the range 50 to 500.
drop: Discards the exceeded packets.
Description
Use the arp rate-limit command to configure or disable ARP packet rate limit. If a rate is specified,
exceeded packets are discarded.
Use the undo arp rate-limit command to restore the default.
By default, ARP packet rate limit is enabled, and the ARP packet rate limit is 100 pps.
Examples
# Specify the ARP packet rate on GigabitEthernet 1/0/1 as 60 pps, and exceeded packets are
discarded.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] arp rate-limit rate 60 drop

ARP Detection Configuration Commands

arp detection enable

Syntax
arp detection enable
undo arp detection enable
View
VLAN view
Default Level
2: System level
Parameters
None
Description
Use the arp detection enable command to enable ARP detection for the VLAN.
Use the undo arp detection enable command to disable ARP detection for the VLAN.
4-9