Dhcp Relay Information Circuit-Id Format-Type; Dhcp Relay Information Circuit-Id String - HP E4510-48G Command Reference Manual

[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay address-check enable

dhcp relay information circuit-id format-type

Syntax
dhcp relay information circuit-id format-type { ascii | hex }
undo dhcp relay information circuit-id format-type
View
Interface view
Default Level
2: System level
Parameters
ascii: Specifies the code type for the circuit ID sub-option as ascii.
hex: Specifies the code type for the circuit ID sub-option as hex.
Description
Use the dhcp relay information circuit-id format-type command to configure the code type for the
non-user-defined circuit ID sub-option.
Use the undo dhcp relay information circuit-id format-type command to restore the default.
By default, the code type for the circuit ID sub-option depends on the specified padding format of
Option 82. Each field has its own code type.
Note that:
This command applies to configuring the non-user-defined circuit ID sub-option only. After you
configure the padding content for the circuit ID sub-option using the dhcp relay information circuit-id
string command, ASCII is adopted as the code type.
Examples
# Configure the code type for the non-user-defined circuit ID sub-option as ascii.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay information circuit-id format-type ascii

dhcp relay information circuit-id string

Syntax
dhcp relay information circuit-id string circuit-id
undo dhcp relay information circuit-id string
View
Interface view
5-2