Commands In The Plug Configuration Mode; Factoryclean - Siemens SCALANCE S615 Configuration Manual

3.1.3

Commands in the Plug Configuration mode

This section describes commands that you can call up in the Plug Configuration mode.
In the Global Configuration mode, enter the
● If you exit the Plug Configuration mode with the
Configuration mode.
● If you exit the Plug Configuration mode with the
Privileged EXEC mode.
3.1.3.1

factoryclean

Description
With this command, you delete the device configuration stored on the C-PLUG or KEY-
PLUG.
Requirement
● There is a device configuration on the C-PLUG or KEY-PLUG.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#
Syntax
Call the command without parameters:
factoryclean
Result
The device configuration on the C-PLUG or KEY-PLUG is deleted.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Functions specific to SCALANCE
command to change to this mode.
plug
command, you return to the Global
exit
command, you return to the
end
3.1 PLUG
89