No Proto - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
Syntax
Call up the command with the following parameters:
proto name <name(32)> num <number(1-254)>
The parameters have the following meaning:
Parameter
name
protonumber
Result
The protocol is configured. If the optional parameters are not specified, a protocol with this
name is created and the default value is used. You can adapt the parameter later.
Further notes
You display this setting and other information with the
command.
You delete the protocol with the
9.2.4.35

no proto

Description
With this command, you delete all protocols or a specific protocol.
Requirement
● The corresponding protocol has been created and is not being used anywhere.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
no proto {name <string(32)> | all}}
346
Description Range of values / note
Protocol name Specify a unique protocol name.
Max. 32 characters
Protocol number 1 ... 254
Default: 254
Specify a protocol number, e.g. 2.
You will find list of the protocol numbers on the Inter-
net pages of iana.org
command.
no proto.
show firewall ip-protocols
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02