Commands In The Ipsec Configuration Mode; Connection Name - Siemens SCALANCE S615 Configuration Manual

Result
You are now in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Further notes
You exit the IPSEC configuration mode with the
9.3.3

Commands in the IPSEC configuration mode

This section describes commands that you can call up in the IPSEC configuration mode.
In the Global configuration mode, enter the
● If you exit the IPSEC configuration mode with the
configuration mode.
● If you exit the IPSEC configuration mode with the
Privileged EXEC mode.
9.3.3.1

connection name

Description
With this command, you change to the IPSEC CONNECTION configuration mode. If a
suitable VPN connection does not exist, a VPN connection is first created.
Requirement
You are in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Syntax
Call up the command with the following parameters:
connection name <name(122)>
The parameter has the following meaning:
Parameter
name
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
ipsec
Description
Name of the VPN connection
Security and authentication
or command.
end exit
command to change to this mode.
command, you return to the Global
exit
command, you return to the
end
Range of values / note
Enter the name for the VPN con-
nection.
Maximum of 122 characters
9.3 IPsec VPN
359