No Ipv4 Rule - Siemens SCALANCE S615 Configuration Manual

9.2.4.10

no ipv4 rule

Description
With this command, you delete all IPv4 firewall rules or a specific IPv4 firewall rule.
Requirement
● The corresponding IPv4 firewall rule has been created and is not being used anywhere.
● You are in the Firewall configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
no ipv4rule {all | idx <integer(1-64)>}
The parameters have the following meaning:
Parameter
ALL
idx
integer
Result
The corresponding IPv4 firewall rule is deleted.
Further notes
You display the IPv4 firewall rule with the
You obtain the numbers with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Deletes all IPv4 rules
Keyword for index
Number corresponding to a specific
IPv4 rule.
command.
ipv4rule
ipv4rule show-rules
Security and authentication
Range of values / note
-
-
Enter the required number.
1 ... 64
command.
9.2 Firewall
323