Network protocols
6.1 IPv4 protocol
6.1.2.1
dcp server
Description
With this command, you configure the read and write permissions for the DCP server and
enable it.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
dcp server {read-only|read-write}
The parameters have the following meaning:
Parameter
read-only
read-write
Result
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
Further notes
You disable the DCP server with the
6.1.2.2
no dcp server
Description
With this command, you disable the DCP server.
Requirement
You are in the Global configuration mode.
176
Description
only reading is permitted on the DCP
server
reading and writing is permitted on the
DPC server
no dcp server
Range of values / note
-
Default:
read-write
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02