Further notes
You delete the settings with the
You display this setting and other information with the
6.1.3.3
no ip address
Description
With this command, you delete the assignment of an IP address to a VLAN interface.
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip address [{ <ucast_addr>}]
The parameter has the following meaning:
Parameter
ucast_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The assignment of the IP address to a VLAN interface is deleted and DHCP is disabled.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, you can lose the connection!
Further notes
You configure the setting with the
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
no ip address
Description
IP Address of the VLAN interface that will
be deleted
ip address
command.
show ip interface
Values
enter a valid IP address
command.
show ip interface
Network protocols
6.1 IPv4 protocol
command.
command.
185