ipv4rule idx <number(1-100)> set to <string(50)> [<integer(0-4094)>]
The parameters have the following meaning:
Parameter
idx
number
to
string
integer
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
Result
The incoming direction of the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the
command.
You obtain the numbers with the
9.2.4.19
ipv4rule ipsec connection
Description
With this command, you list the firewall rules for the IPsec connections.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call the command without parameter assignment:
ipv4rule ipsec connection show-idx
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for index
Number corresponding to a spe-
cific IPv4 rule.
Keyword for the incoming direc-
tion (to)
Interface that receives the IPv4
packet
Number of the interface
ipv4rule show-rules
Security and authentication
Range of values / note
-
Enter the required number.
1 ... 100
-
Specify a valid interface.
Maximum of 50 characters
0 ... 4094
show firewall ip-rules ipv4
command.
9.2 Firewall
331