Further notes
You display this setting and other information with the show ipsecvpn information command.
9.3.3.6
remote-end name
Description
With this command, you change to the REMOTE END configuration mode. In this mode, you
configure the other settings.
If the matching VPN remote station does not exist, the VPN remote station is first created.
Requirement
You are in the IPSEC configuration mode.
The command prompt is as follows:
cli(config-ipsec)#
Syntax
Call up the command with the following parameters:
remote-end name <name(100)>
The parameter has the following meaning:
Parameter
name
Result
You are now in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
X is a placeholder for the name
Further notes
You exit the IPSEC REMOTE END configuration mode with the
You delete a VPN remote station with the
You delete all VPN remote stations with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Name of the VPN remote station
no remote-end name
no remote-end all
Security and authentication
9.3 IPsec VPN
Range of values / note
Enter the name for the VPN re-
mote station.
or
command.
end
exit
command.
command.
363