In the Global configuration mode, enter the sinemarc command to change to this mode.
● If you exit the SINEMARC configuration mode with the
Global configuration mode.
● If you exit the SINEMARC configuration mode with the
Privileged EXEC mode.
3.5.4.1
addr
Note
This command is only available with a KEY-PLUG.
Description
With this command you configure the IPv4 address or the DNS host name of the SINEMA
RC Server.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call up the command with the following parameters:
addr <ip_addr|dns(50)>
The parameters have the following meaning:
Parameter
ip_addr
dns
Result
The IPv4 address of the SINEMA RC Server is configured.
Further notes
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Range of values / note
IPv4 address
Enter the IPv4 address of the SINEMA RC Server.
DNS host name
Enter the DNS host name of the SINEMA RC Server.
Maximum of 50 characters
Functions specific to SCALANCE
3.5 SINEMA RC
command, you return to the
exit
command, you return to the
end
command.
show sinemarc
111