Security and authentication
9.4 Certificates
9.4.2.3
del
Description
With this command, you delete a specific certificate or all certificates.
Requirement
● Certificates are loaded and are not being used anywhere.
● You are in the CERT configuration mode.
The command prompt is as follows:
cli(config-cert)#
Syntax
Call up the command with the following parameters:
del { <idx(1-100)> | all }
The parameters have the following meaning:
Parameter
idx
all
Result
The relevant certificate is deleted.
Further notes
You load certificates with the
You show the available certificates with the
You display the use of the certificate with the
410
Description
Number corresponding to a specific certificate.
Deletes all certificates.
command.
tftp load
show-idx
Range of values / note
Enter the required number.
1 ... 100
---
command.
command.
show-info
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02