Ipv4Rule Set From - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
9.2.4.13

ipv4rule set from

Description
With this command, you change the outgoing direction.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set from <string(50)> [<integer(0-4094)>]
The parameters have the following meaning:
Parameter
idx
number
from
string
integer
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
Result
The outgoing direction of the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the
command.
You obtain the numbers with the
326
Description
Keyword for index
Number corresponding to a spe-
cific IPv4 rule.
Keyword for the outgoing direc-
tion (from)
Interface that sends the IPv4
packet
Number of the interface
ipv4rule show-rules
Range of values / note
-
Enter the required number.
1 ... 100
-
Specify a valid interface.
Maximum of 50 characters
0 ... 4094
show firewall ip-rules ipv4
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02