Dpd-Timeout; Ike-Auth - Siemens SCALANCE S615 Configuration Manual

9.3.7.8

dpd-timeout

Description
With this command, you configure the timeout setting for the VPN connection. If there is no
response to the DPD queries, the connection to the remote station is declared to be invalid
after this time has elapsed.
Requirement
● DPD is enabled
● You are in the IPSEC PHASE configuration mode.
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
dpd-timeout <sec(10-1000)>
The parameter has the following meaning:
Parameter
sec
Result
The period of time is configured.
Further notes
You display this setting and other information with the
You enable DPD with the
9.3.7.9

ike-auth

Description
With this command, you configure the method for calculating the checksum.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
The command prompt is as follows:
Description
Period for DPD queries
dpd
command.
Security and authentication
Range of values / note
Enter the period of time in sec-
onds.
show ipsec conn-phase1
9.3 IPsec VPN
command.
391