Security and authentication
9.3 IPsec VPN
Requirement
● The default list is not used.
● You are in the IPSEC PHASE configuration mode.
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
ike-auth {md5|sha1|sha512|sha256|sha384}
The parameters have the following meaning:
Parameter
md5
sha1
sha512
sha256
sha384
Result
The method for configuring the checksum is configured.
Further notes
You display this setting and other information with the
You disable the use of the default list with the
9.3.7.10
ike-encryption
Description
With this command, you configure the encryption algorithm.
392
The command prompt is as follows:
Description
Message Digest Algorithm 5
Secure Hash Algortihm 1 with 160 bit
hash length
Secure Hash Algorithm 2 with 512 bit
hash length
Secure Hash Algorithm 2 with 256 bit
hash length
Secure Hash Algorithm 2 with 384 bit
hash length
Range of values / note
-
-
-
-
-
show ipsec conn-phase1
command.
no default-ciphers
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.