Commands In The Firewall Nat Configuration Mode - Siemens SCALANCE S615 Configuration Manual

Layer 3 functions
8.1 NAT
Syntax
Call the command without parameters:
firewallnat
Result
You are now in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Further notes
You exit the FIREWALL NAT configuration mode with the
8.1.3

Commands in the FIREWALL NAT configuration mode

This section describes commands that you can call up in the FIREWALL NAT configuration
mode.
In the Global configuration mode, enter the
● If you exit the FIREWALL NAT configuration mode with the
the Global configuration mode.
● If you exit the FIREWALL NAT configuration mode with the
the Privileged EXEC mode.
Available interfaces
As the source and destination interfaces, the following interfaces are available:
Interface
VLAN
PPP
(M874,
M876-3)
USB
(M876-4)
IPsecVPN
SINEMA RC Connection to SINEMA RC Server
x: available
- : not available
288
VLANs with configured subnet
WAN interface EGPRS, GPRS,
UMTS
WAN interface LTE
All IPsecVPN connections
Specific IPsecVPN connection
or
end exit
command to change to this mode.
firewallnat
exit
end
masquerading- netmap
nat
src-nat
napt
x x
x x
x x
- x
- x
- x
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
command, you return to
command, you return to
vlan num
ppp 0
usb 0
ipsecALL
ipsec num
sinemarcall