No Smtp-Server - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.10 SMTP client
Parameter
FQDN(100)
receiver mail-
address
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the
6.10.2.4

no smtp-server

Description
With this command, you delete an SMTP server entry.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no smtp-server {ipv4 <ucast_addr> | fqdn-name <FQDN(100)>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN(100)
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
270
Description
Domain name (Fully Qualified Domain
Name)
Name of the recipient
no smtp-server
Description
Keyword for an IP address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Note on the range if values
Maximum of 100 characters
max. 100 characters
command.
Range of values/note
-
Enter a valid IPv4 unicast ad-
dress.
-
Maximum of 100 characters
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02