The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call the command without parameter assignment:
no rem-id
Result
The remote ID is removed.
Further notes
You display this setting and other information with the
command.
You configure the remote ID with the
9.3.7
Commands in the IPSEC PHASE1 configuration mode
This section describes commands that you can call up in the IPSEC PHASE configuration
mode.
In the IPSEC CONNECTION configuration mode, enter the
this mode.
● If you exit the IPSEC PHASE1 configuration mode with the
the IPSEC CONNECTION configuration mode.
● If you exit the IPSEC PHASE1 configuration mode with the
the Privileged EXEC mode.
9.3.7.1
aggressive
Description
With this command you specify that the aggressive mode will be used.
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
show ipsec conn-authentication
command.
rem-id
phase 1
Security and authentication
9.3 IPsec VPN
command to change to
command, you return to
exit
command, you return to
end
385