Vir-Ip - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
subnet <subnet|dns>
The parameters have the following meaning:
Parameter
subnet
dns
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The remote subnet is configured.
Further notes
You display this setting and other information with the
9.3.4.5

vir-ip

Description
With this command, you specify the subnet from which the remote station is offered a virtual
IP address.
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
vir-ip ipv4 [<subnet>]
370
Description
IP subnet
DNS name
Range of values / note
Specify the subnet.
Specify the DNS host name.
show ipsec remoteend
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.