Write Startup-Config; Commands In The Global Configuration Mode - Siemens SCALANCE S615 Configuration Manual

Configuration
2.4 Configuration Save & Restore
2.4.2

write startup-config

Description
With this command, you save the changes to the configuration in the configuration file.
The use of this command is required in the Trial mode. It can also be used in "auto save
mode".
Requirement
● The Trial mode is activated.
● You are in the Privileged EXEC mode.
The command prompt is:
*cli(...)#
Syntax
Call the command without parameter assignment:
write startup-config
Result
The changes are saved in the configuration file.
Use the
Further notes
You enable the auto save function or disable the Trial mode with the
You disable the auto save function or enable the Trial mode with the
command.
2.4.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
84
command without parameters to restart the system with this configuration.
restart
command to change to this mode.
configure terminal
or
end exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
auto-save
no auto-save
command and are then in the