Commands In The Global Configuration Mode - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.3 DHCP client
Syntax
Call up the command with the following parameters:
renew dhcp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-
type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
Result
The IP address is assigned again.
This address can be a different address from the previously assigned address.
Further notes
You can display the statistical information of the DHCP client with the
stats
You show the statistical information and the configuration of the IP interface with the
interface
See also
Interface identifiers and addresses (Page 25)
6.3.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
188
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
command.
command.
command to change to this mode.
configure terminal
or
end exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Range of values
-
1 ... 4094
Enter a valid interface.
show ip dhcp client
command and are then in the
show ip