No Ip Routing - Siemens SCALANCE S615 Configuration Manual

Result
The routing function is enabled.
Further notes
You disable the function with the
You display the setting with the
6.1.2.8

no ip routing

Description
With this command, you disable IPv4 routing function on the device.
Note
IPv6 routing
If IPv6 routing is enabled on the device, this is also disabled with this function.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip routing
Result
IPv4 routing is disabled.
Further notes
You enable the function with the
You display the setting with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
no ip routing
command.
show ip route
command.
ip routing
command.
show ip route
Network protocols
6.1 IPv4 protocol
181