Loc-Subnet - Siemens SCALANCE S615 Configuration Manual

Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(onfig-conn-X)#
Syntax
Call up the command with the following parameters:
k-proto {ikev1|ikev2}
The parameters have the following meaning:
Parameter
IKE1
IKEv2
Result
The setting is configured.
Further notes
You display this setting and other information with the
9.3.5.3

loc-subnet

Description
With this command, you configure the local subnet.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Syntax
Call up the command with the following parameters:
loc-subnet <subnet|dns>
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Uses IKEv1
Uses IKEv2
Security and authentication
Range of values / note
-
-
show ipsec connections
9.3 IPsec VPN
command.
373