Show Im - Siemens SCALANCE S615 Configuration Manual

Configuration
2.1 System
The parameters have the following meaning:
Parameter
interface-type
interface-id
description
status
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the status and configuration of
all available interfaces will be displayed.
Result
The status and the configuration of the selected interfaces are displayed.
2.1.1.5

show im

Description
This command shows information on device-specific vendor and maintenance data such as
the article number, serial number, version numbers etc.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show im
Result
The information is displayed.
40
Description
Type or speed of the interface
Module no. and port no. of the interface
Shows the description of the interface
Shows the status of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
or
cli#
Range of values / note
Enter a valid interface.
-
-
-
1 ... 4094
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02