Layer 3 functions
8.1 NAT
8.1.3.6
napt show-idx
Description
With this command, you show the numbers of the configured NAPT rules.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call the command without parameter assignment:
napt show-idx
Result
The numbers are listed.
Further notes
You delete a NAPT rule with the
You create a NAPT rule with the
8.1.3.7
netmap destination type ipv4
Description
With this command, you create the NETMAP rule for the address translation of the
destination IP address.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
294
command.
no napt
command.
napt
Configuration Manual, 06/2015, C79000-G8976-C406-02
SCALANCE S615 Command Line Interface