9.2.4.12
ipv4rule set dstip
Description
With this command, you change the destination.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set dstip <ip_addr>
The parameters have the following meaning:
Parameter
idx
number
dstip
string
Result
The destination of the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the
command.
You obtain the numbers with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for index
Number corresponding to a spe-
cific IPv4 rule.
Keyword for the destination
Address that receives IPv4 pack-
ets.
ipv4rule show-rules
Security and authentication
Range of values / note
-
Enter the required number.
1 ... 100
-
Individual IP address: Specify the IP
•
address.
IP range: Specify the range with the
•
start address "-" end address,
e.g.192.168.100.10 - 192.168.100.20.
All IP addresses: Specify " 0.0.0.0/0".
•
show firewall ip-rules ipv4
command.
9.2 Firewall
325