Pool-Enable - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.4 DHCP server
The parameters have the following meaning:
Parameter
option-code
dhcp-param
Result
The DHCP option is configured. In total a maximum of 20 DHCP options are possible.
Further notes
You display the setting with the
You disable the IPv4 address band with the
You delete the DHCP option with the
6.4.3.6

pool-enable

Description
With this command you specify that this IPv4 address band will be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
pool-enable
202
Description
Code of the DHCP option
DHCP parameter in hexadecimal
show ip dhcp-server-pools
no option
Range of values / note
Enter a valid DHCP option.
The following DHCP options are not sup-
ported:
50 - 60
•
255
•
Enter a valid hexadecimal value.
Format: XXXXX e.g. C0A86402
command.
command.
no pool-enable
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02