Prerule Https Ipv4 - Siemens SCALANCE S615 Configuration Manual

Parameter
enabled
disabled
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
Result
The predefined firewall rule HTTP is enabled on the relevant interface. The WBM can be
accessed using HTTP.
Further notes
You display this setting and other information with the
command.
You list the available interfaces with the
See also
Commands in the FIREWALL configuration mode (Page 313)
9.2.4.26

prerule https ipv4

Description
With this command, you enable the predefined firewall rule for HTTPS on the selected
interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule http ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
int
interface-type
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Enables the predefined firewall rule.
Disables the predefined firewall rule.
prerule ipv4 show-int
Description
Keyword for the interface
Type or speed of the interface
Security and authentication
Range of values / note
-
-
show firewall pre-rules ipv4
command.
Range of values / note
-
Specify a valid interface.
9.2 Firewall
337