Network protocols
6.1 IPv4 protocol
6.1.2.9
telnet-server
Description
With this command, you enable the Telnet server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
telnet-server
As default the function is "enabled".
Result
The Telnet server is enabled.
Further notes
You disable the Telnet server with the
6.1.2.10
no telnet-server
Description
With this command, you disable the Telnet server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no telnet-server
182
command.
no telnet-server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02