8.1.1.4
show firewallnat src-nat
Description
This command shows the configured source NAT rules.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show firewallnat src-nat
Result
The configured source NAT rules are displayed.
8.1.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.1.2.1
firewallnat
Description
With this command, you change to the FIREWALL NAT configuration mode.
Requirement
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command to change to this mode.
configure terminal
or
end
exit
Layer 3 functions
command and are then in the
8.1 NAT
287