Network protocols
6.4 DHCP server
6.4.1.2
show ip dhcp-server pools
Description
The command shows the DHCP server configuration of a specific IPv4 address band or all
IPv4 address bands and the corresponding DHCP options.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip dhcp-server pools [pool-id (1-5)]
The parameter has the following meaning:
Parameter
pool-id
Result
The configuration of the DHCP server and the DHCP options is displayed.
6.4.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
192
or
cli#
Description
ID of the addressed IPv4 address
band
Range of values / note
1 ... 5
command to change to this mode.
configure terminal
or
end
exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command and are then in the