Siemens SCALANCE S615 Configuration Manual page 322

Security and authentication
9.2 Firewall
Parameter
drop
rej
service
name
log
none
info
war
cri
prior
integer
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
Result
The IPv4 rule is created. When it is created, the IPv4 rule is automatically given a unique
number (index).
Further notes
You display this setting and other information with the
command.
You create a service with the following commands:
You create a protocol with the
You change the settings with the commands
322
Description
The data packets are discarded
without any notification to the
sender.
The data packets are rejected,
and the sender receives a corre-
sponding message.
Keyword for service or protocol
name
Service or protocol name for
which this rule is valid
Keyword for making entries in the
firewall log
The rule coming into effect is not
logged.
Messages about event severity
" " are logged.
information
Messages about event severity
" " are logged.
warning
Messages about event severity
" " are logged.
critical
Keyword for the priority
Priority
command.
proto name
Range of values / note
-
-
-
Enter a valid name.
-
-
-
-
-
-
Enter the priority for the IPv4 rule.
0 ... 64
show firewall ip-rules ipv4
,
icmp name service name
and .
ipv4rule set...
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
.