2.1.10.1
alias
Description
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
alias <port-name>
The parameter has the following meaning:
Parameter
port-name
Result
The interface was assigned a name.
Further notes
You delete the name of the interface with the
2.1.10.2
no alias
Description
With this command, you delete the name of the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Name of the interface
no alias
Range of values / note
max. 63 characters
command.
Configuration
2.1 System
59