No Snmp Notify - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.6 SNMP
Parameter
Type
Storage type
Result
The details of the SNMP notifications are configured.
Further notes
You delete the details of an SNMP group with the
You display the configured SNMP notifications with the
You display the configured SNMP target addresses with the
command.
6.6.2.13

no snmp notify

Description
With this command, you delete the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp notify <NotifyName>
240
Description
Type of the SNMP notification
specifies whether the settings remain
following a restart:
Range of values / note
•
Trap
generates a trap
•
Inform
generates a log entry or sends
an entry to the log server
•
volatile
The settings are lost after a
restart
•
nonvolatile
The settings are retained after
a restart
command.
no snmp notify
show snmp notif
show snmp targetaddr
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
(volatile):
(non-volatile):
command.