No Name; Ports - Siemens SCALANCE S615 Configuration Manual

Network structures
5.1 VLAN
5.1.4.4

no name

Description
With this command, you delete the name assignment for a VLAN.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameters:
no name
Result
The name of the VLAN is deleted.
Further notes
You assign the VLAN a name with the command
5.1.4.5

ports

Description
With this command, you generate a list that specifies the behavior of the interfaces and
replaces the existing VLAN configuration.
● Member ports (tagged ports)
The interface is added permanently to the list of incoming and outgoing connections.
Tagged and untagged frames are transferred.
● Untagged Ports
untagged frames are given a tag with the VLAN ID specified there. If the received frames
already contain a VLAN ID, frames are only accepted if their VLAN ID matches the set
PVID. With outgoing frames, the tag with the VLAN ID is removed.
● Forbidden Ports
The "tagged port" and "untagged port" you specify with this command are used for outgoing
data traffic.
166
The interface transfers untagged frames. If the VLAN ID (PVID) is set, incoming
This interface is not used for communication in a VLAN.
.
name
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02