Syntax
Call the command without parameter assignment:
src-nat del all
Result
The source NAT rules are created.
Further notes
You create a source NAT rule with the
8.1.3.14
src-nat show-idx
Description
With this command, you show the numbers of the configured source NAT rules.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call the command without parameter assignment:
src-nat show-idx
Result
The numbers are listed.
Further notes
You delete a source NAT rule with the
You delete all source NAT rules with the
You create a source NAT rule with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
. command.
src-nat type ipv4
command
no src-nat.
command.
no src-nat all
command.
src-nat type ipv4
Layer 3 functions
8.1 NAT
301