Napt Type Ipv4 - Siemens SCALANCE S615 Configuration Manual

Layer 3 functions
8.1 NAT
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
no masquerading {<interface-type> <num(0-4094)>|all-int|show-int}
The parameters have the following meaning:
Parameter
interface-type
num
all-int
show-int
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The rules for IP masquerading are disabled on the relevant interface.
Further notes
You enable IP masquerading with the
8.1.3.3

napt type ipv4

Description
With this command, you create a NAPT rule.
Requirement
● VLAN interface with subnet assignment
● You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
290
Description
Type or speed of the interface
Number corresponding to a specific interface.
Disables the rules for IP masquerading on all
interfaces.
Lists the available interfaces.
masquerading-nat
Range of values / note
Specify a valid interface.
Enter the required number.
0 ... 10
-
-
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02