Siemens SCALANCE S615 Configuration Manual page 167

Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ports
(
[
]
[
[name<vlan-name>]
The parameters have the following meaning:
Parameter
interface-type
/a-b,0/c,...
untagged
all
forbidden
name
vlan-name
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The settings are enabled.
Further notes
You display details of the function with the
You reset the settings with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
)
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>]
)
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
]
Description
Type or speed of the interface
Port no. of the interface
Keyword for interfaces or ports that transfer
data packets without VLAN marking
Specifies that all interfaces or ports are set to
"untagged"
Keyword for forbidden interfaces or ports
Keyword for the name assignment
Name of the VLAN
[all]
command.
show vlan
command.
no ports
Network structures
5.1 VLAN
Values
Specify a valid interface.
-
-
-
-
max. 32 characters
167