Src-Nat Type Ipv4 - Siemens SCALANCE S615 Configuration Manual

Layer 3 functions
8.1 NAT
Result
The numbers are listed.
Further notes
You delete a NETMAP rule with the
You delete all NETMAP rules with the
You create a NETMAP rule with the commands
destination type ipv4
8.1.3.11

src-nat type ipv4

Description
With this command, you create a rule for source NAT.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
src-nat srcint <if-type> [<num(0-4094)>] dstint <if-type> [<num(0-4094)>] type ipv4
srcip <ip_addr|ip_range|subnet> dstip <ip_addr|ip_range|subnet> transip
<auto|ip_addr>
The parameters have the following meaning:
Parameter
srcint
if-type
num
dstint
if-type
num
srcip
ip_addr
ip_range
subnet
298
no netmap
no netmap all
.
Description
Keyword for the source interface
Type or speed of the interface
Number of the addressed interface
Keyword for the destination interface
Type or speed of the interface
Number of the addressed interface
Keyword for the source IP address.
IPv4 address
IPv4 address range
IPv4 address for the subnet
command.
command.
netmap source type ipv4
Range of values / note
-
Specify a valid interface.
0 ... 4094
-
Specify a valid interface.
0 ... 4094
Enter a valid IPv4 address.
Specify a valid IPv4 address
range.
Specify the subnet in CIDR
notation.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
and
netmap